Question Wizard air regulator attachment on retractable wall mount

Create a Post
Ryan Hoerner

Ryan Hoerner

Grumbler in Training
Joined
Mar 8, 2025
Posts
12
Loc
Buffalo, NY
Business
Buffalo Big Print
Anybody know where to attach the regulator on the retractable wall mount? I cant seem to find holes anywhere that line up
 
I have the stationary wall mount, and my regulator came with a metal bracket that I have screwed to the wall near the machine mount.
If you don't have a bracket for your regulator, you might be able to get one from Wizard, or wherever pneumatic tools and fittings are sold.
:cool: Rick
 
Ryan Hoerner said:
Anybody know where to attach the regulator on the retractable wall mount? I cant seem to find holes anywhere that line up
Click to expand...
It looks like we attached our regulator to one of the cross supports (against the wall) on our retractable wall mount.
 
alacrity8 said:
It looks like we attached our regulator to one of the cross supports (against the wall) on our retractable wall mount.
Click to expand...
Did it have pre drilled holes? I guess I can just mount it to the wall I just thought they would have had a clear area to mount it since everything else is very clearly labeled and easy to assemble. Thanks for the response!
 
Rick Granick said:
I have the stationary wall mount, and my regulator came with a metal bracket that I have screwed to the wall near the machine mount.
If you don't have a bracket for your regulator, you might be able to get one from Wizard, or wherever pneumatic tools and fittings are sold.
:cool: Rick
Click to expand...
Thanks Rick, I did have the mount included. But it has directions for the fixed wall mount and the table set up but not the retractable wall mount. I’m just going to end up mounting to the wall but would have thought there were pre drilled and tapped holes since the screws that come with it are threaded.
 
It looks like we only used some of the screw holes on the lower cross support to attach it the stand to the wall.
We used one of the unused holes to attach the Regulator.
 
alacrity8 said:
It looks like we only used some of the screw holes on the lower cross support to attach it the stand to the wall.
We used one of the unused holes to attach the Regulator.
Click to expand...
Thanks I appreciate the information, I’ll likely due something similar, I thought it was odd they included threaded blots like they were meant to go somewhere specific. My cross supports are tight against the wall connected directly to studs so the empty ones would have no support and it’s too late to add a wall anchor now that the machine is up. I’ll likely just mount it underneath to the wall which is easy enough. The install directions are so specific and accurate everywhere else except this one instance that’s why I thought maybe I’m not understanding and should ask some grumble goblins. Thanks again!
 
The regulator is most likely a catalog item from a supplier of theirs. As such they might have many companies ordering the same regulator leaving extra hardware in the bag that it was originally in with most often used hardware that other customers might use. It's a matter of packaging for a generic use vs multiple packages(and SKUs) for the vendor, IE cost saving for the vendor.
 
Create a Post
Back
Top