C
Cliff Wilson
Guest
Ok, I know this should be easy!?
I can't seem to figure it out.
I have a number of openings in thsi mat. There is "title/date double opening at the top that has too much mat around it. I'd like to break it up with a v-groove. BUT, I don't want a complete rectangle. How? I'll try to illustrate ...
.......+----------------------------+
.......|......+--------------+.........|
.......|......|...................|.........|
.......|......+--------------+........|
.......|.....................................|
.......|..............+-----+............|
.......+------+...+.......+.....+---+
......................+-----+
Hope that is understandable? BTW, I have the Wizard Jr. program, so I do not have the CADD software.
Thanks,
Well, the right side looks a little raged to me, but hopefully you get the idea.
I can't seem to figure it out.
I have a number of openings in thsi mat. There is "title/date double opening at the top that has too much mat around it. I'd like to break it up with a v-groove. BUT, I don't want a complete rectangle. How? I'll try to illustrate ...
.......+----------------------------+
.......|......+--------------+.........|
.......|......|...................|.........|
.......|......+--------------+........|
.......|.....................................|
.......|..............+-----+............|
.......+------+...+.......+.....+---+
......................+-----+
Hope that is understandable? BTW, I have the Wizard Jr. program, so I do not have the CADD software.
Thanks,
Well, the right side looks a little raged to me, but hopefully you get the idea.