Hi folks...new here! I was signposted here from a Fb group.
I'm wondering if anyone could help me.
So...I have a basic bench morso underpinner (no idea what model as was second hand- looks like UP-M) which is operated by a hydraulic foot pedal. Lately it hasn't been firing the vnails with enough force, and investigations pointed to lack of hydraulic pressure. This issue is now fixed, but as the whole thing was covered in crap I gave it a good clean. Sadly, getting loads of nasty gunk off it has resulted in totally messing with the alignment. It now shoots vnails off centre...which means awful joins.
What would one usually tweek in order to solve the problem?
I used a set square to align the fences, so it seems like the block and whole cartridge/chute bit is off centre
Any thoughts appreciated.
Thanks,
Holly x
I'm wondering if anyone could help me.
So...I have a basic bench morso underpinner (no idea what model as was second hand- looks like UP-M) which is operated by a hydraulic foot pedal. Lately it hasn't been firing the vnails with enough force, and investigations pointed to lack of hydraulic pressure. This issue is now fixed, but as the whole thing was covered in crap I gave it a good clean. Sadly, getting loads of nasty gunk off it has resulted in totally messing with the alignment. It now shoots vnails off centre...which means awful joins.
What would one usually tweek in order to solve the problem?
I used a set square to align the fences, so it seems like the block and whole cartridge/chute bit is off centre
Any thoughts appreciated.
Thanks,
Holly x
