Terry Hart cpf
SGF, Supreme Grumble Framer
Sorry if this has been covered & I missed it but I'm wondering how Lifesaver users handle stacked mouldings as ther is a problem with the way it comes out. To start with, it is a little unclear to me which order to enter mouldings in on the software as the fields are not labeled. It is however headed: Moulding/Fillet so I take that to mean enter the outer most frame first & work your way in. When the work order prints out it then shows the correct dimention for the inner frame but the footage shown required seems to be for the outer frame & the footage shown for the outer frame actually corresponds to the inner frame requirement so the pricing is actually off. Then when I print the pick sheet it treats the inner frame as if it were the outer ( says' "stacked" & shows no dimention ) & the outer frame prints out with the dimention that belongs to the inner frame on the pick list. This is confusing me mightily. Maybe I have this wrong but the point is that the information on the pick list shows opposite of that on the workorder. Any help?
