SOUPED UP WIZARD

Bob Shirk MCPF

CGF II, Certified Grumble Framer Level 2
Joined
Dec 27, 2000
Posts
247
Loc
Shippensburg, PA USA
I have added two self stick tape measures to my Wizard. one is on the bottom rail with the zero point at the right end of the board clamp. The other one is on the side of the gantry with the zero point alligned with the bottom clamp. This setup allows me to determine at a glance if I have a matboard of the corect size in the machine.

I'd like to hear from other Grumblers about modifications and additions that they have made to their Wizards to improve performance. :cool:
 
I think that was in PFM in the Counter Inteteligence.

It is a huge time and effort saver.

What I'd like to see to a "holster" or attached compartment with small separators for putting all those tiny part or tools in.

Y'know something to put the extra boxes of blades in.

Also what is a great addition is magnets: Magentic paper file holders.

Magents to hold paper or workorders to the machine.

Magnetic fridge clips are GREAT. Like the ones you use on the bag of chips.

Also the you can just attach some small round strong ones and place tools on them.
 
Yes, on the body of the machine. Not the computer, motors, or monitors.

Also, in case you had trouble getting them to stick; They don't stick too well on the parts made from aluminum.
 
Back
Top