Question Seal 4466 press parts

Create a Post
neilframer

neilframer

PFG, Picture Framing God
Forum Donor
Joined
Jan 27, 2010
Posts
8,781
Loc
Phoenix, AZ
Business
Rectangles
Does anyone have a link or contact to the company that supplies parts for an older Seal 4466 heat vacuum press? It was Hunt, then Bienfang, and now it's Onsite or something like that. Any help would be appreciated. :help:
 
I found the On-Site Maintenance phone number on an old thread.
866-667-4836. Will try on Monday to see if they've got the part.
 
The foam seal around the bladder is broken down. I don't know if I have to buy the whole bladder or if the seal is available by itself. The rubber bladder is OK, just the seal is bad.
 
I'm not sure. :( (Sorry I'm not more help.)

I'm guessing our presses are about the same age--I have the 3646....but my diaphragm and seal are in great shape. I think it was probably replaced before I got it. Mine is in storage and I'll probably wind up parting it out.

I've heard that if the foam is crushed, you can shim it with foamcore...but if the seal is separated, I don't know. :(
 
Thanks for the reply. This press worked when I put it in storage about 6 months ago, but I looked at it today and the seal looked sort of flat. The Arizona summer heat may have gotten to it in storage. I can't test it because there is no 220 volt access. Possibly it could be shimmed. Thanks again. :icon21:
 
Thanks for the info and ideas everybody. :thumbsup:
The press is actually a 4366 not a 4466. Does anyone have a manual or link for one for a Seal 4366?
 
Create a Post
Back
Top