Bob Morgan
Grumbler
Would like advice on the best miter saw blade to use...........one that cuts gesso also .........
Tks..............
Tks..............
Saw blade
- Thread starter Bob Morgan
- Start date
-S-
CGF, Certified Grumble Framer
Hi, Bob
I use a carbide-tipped, triple-chip saw blade (10", I think, with 80 teeth). Cuts wood and metal. I have two; when one is on the saw, the other is at the shop for sharpening.
Hope this helps...
I use a carbide-tipped, triple-chip saw blade (10", I think, with 80 teeth). Cuts wood and metal. I have two; when one is on the saw, the other is at the shop for sharpening.
Hope this helps...
Framerguy
PFG, Picture Framing God
Bob,
Try a search for "saw blades" from the tool bar above. We have talked about saw blades manymanymanymanymany times. You should find everything you ever wanted to know about saw blades somewhere in there.
Good luck.
Try a search for "saw blades" from the tool bar above. We have talked about saw blades manymanymanymanymany times. You should find everything you ever wanted to know about saw blades somewhere in there.
Good luck.
Danimal
CGF II, Certified Grumble Framer Level 2
Somebody Stop Me!
We get ours from Ultramitre in California. One of their staff gave a program at our PPFA chapter that was very enlightening. Give them a call.