framer12056
Grumbler in Training
- Joined
- Apr 29, 2010
- Posts
- 7
Hello, I have a Bienfang 3648 vacuum press which is not getting any pressure. I purchased the table a few years back, and had it up and running for several years and it ran perfectly. We recently moved the table to our new home, and after setup it heats to temp, but no vacuum. I have tried the following:
Covered both vacuum intakes with plastic, and I get 28 hg
unscrewed the hinges and repositioned the top several times, but no vacuum
verified the table is completely level.
Removed and replaced the thin foam strips all around the underneath of the diaphragm.
Placed weight on all sides of the top to see if I could get a better seal, but nothing.
I tried to place a candle all around the openings while running to see if any smoke was drawn in, but I cannot see anything.
Are there any other tricks out there that I could try ?
Can anyone direct me on where I could hire a technician to come out and look at it ?
Thank You in advance.
Covered both vacuum intakes with plastic, and I get 28 hg
unscrewed the hinges and repositioned the top several times, but no vacuum
verified the table is completely level.
Removed and replaced the thin foam strips all around the underneath of the diaphragm.
Placed weight on all sides of the top to see if I could get a better seal, but nothing.
I tried to place a candle all around the openings while running to see if any smoke was drawn in, but I cannot see anything.
Are there any other tricks out there that I could try ?
Can anyone direct me on where I could hire a technician to come out and look at it ?
Thank You in advance.