Question Mosaic tiles on mesh backing

debbè88

Grumbler in Training
Joined
Jul 5, 2021
Posts
9
Loc
nj
Business
michaels
Have a cust that has a 91" x 46" mosaic tile pieces on mesh backing they want framed.... what kind of adhesive is needed to mount it, what do you mount to and doesn't the molding depth & size configure with the size & weight of the tiles?
 
To the point!

That is something that should be on the floor. The mesh is to make the placement of each piece easier.
You would have to use tile cement and affix this to a strong and rigid backing. Something like Hardie board or cementite. That will double the weight. Add on the grout and a frame and you're trying to hang a 200 lb.+ object on the wall. The wall will have to be reinforced, and the hanging mechanism will have to be integral with the mount.
Good luck. Run away! Run away!!!
 
To the point!

That is something that should be on the floor. The mesh is to make the placement of each piece easier.
You would have to use tile cement and affix this to a strong and rigid backing. Something like Hardie board or cementite. That will double the weight. Add on the grout and a frame and you're trying to hand a 200 lb+ object on the wall. The wall will have to be reinforced, and the hanging mechanism will have to be integral with the mount.
Good luck. Run away! Run away!!!
You beat me to it. I was going to suggest you call your local tile installer and have them offer suggestions - if they don't laugh you out of their shop. :faintthud:
 
A shining moment...I beat Larry Peterson to the answer! I can now retire in peace...
 
You beat me to it. I was going to suggest you call your local tile installer and have them offer suggestions - if they don't laugh you out of their shop. :faintthud:
I just had a local tile installer in my shop.

I have done single tile pieces, and mosaics up to 25 pieces, but never over 30"x30".
That part really should be done by a professional.
 
Another alternative:
Put it on the floor with suitable grout, as it was intended to be used.

Then take a high-resolution photo of it and have it printed in full size. Frame that. It would still be big and heavy, but your customer will not have to be concerned about the assembly falling apart or the wall collapsing under the concentrated weight.
 
Another alternative:
Put it on the floor with suitable grout, as it was intended to be used.

Then take a high-resolution photo of it and have it printed in full size. Frame that. It would still be big and heavy, but your customer will not have to be concerned about the assembly falling apart or the wall collapsing under the concentrated weight.
...or being able to take it with them when they move in the future.
:coffeedrinker2: Rick
 
Back
Top