Miter Saw Measuring Guide

[FramingFool]

I'm looking for a source for the graduated measuring strip used with a miter saw. I saw them once but can't recall where. The one I'm looking for has an adhesive backing and is graduated in 1/8" increments, the purpose of this is to replace one which is too worn to read.

 

[joe]

I don't know if this is what you need but go to: www.biesemeyer.com and then click on"products" then "mitre" and then "tapes"...I think. If this isn't what you need then I would go to woodonline.com and ask the question on their woodworking forum.

Joe Jaquess

 

[Framerguy]

If you table is a Phaedra, you can order a new decal from them. I have had mine for 14 years and can still read mine like it was new. Most of them are colored completely through the plastic decal.

Framerguy

 

[Perimeters]

Woodcraft sells these. http://www.woodcraft.com. They have both "left to right" and "right to left" rules with self adhesive backing.
the part numbers are:
08Y41 - 6 foot L-R $9.99
08Y42 - 6 ffoot R-L $9.99
08Y40 set of two (one of each of above) - $17.99
08W12 - 12 ft L-R $10.99
08W13 - 12 ft R-L $13.99
08W10 Set of two (one each of above) 21.99

 

[Framerguy]

FF,

Are you looking for a regular glue-down rule like a tape rule or are you looking for the graduated 4" wide decal that is used on the calibration table of a chop saw setup??

I may have misunderstood what it was you were looking for. The decal that I referred to is specially made for a Phaedra or similar chop saw calibration table and is a dedicated rule to actually cut mitered lengths of frame moulding.

I suspect either I am confused or everyone else is because most of the posts are for regular stick-down tape measures.

Framerguy