Looking for Keencutter for fine art prints, Coroplast and Gatorboard.

Dan Berg

CGF, Certified Grumble Framer
Joined
Feb 15, 2009
Posts
171
From
Mohnton,Pa.
We have a 36" Rotatrim but need something a good bit larger that can trim our large 60" prints as well as trim gator board that has prints attached.
We have the Keencut Steeltrac for breaking down gator but it is not accurate enough for print trimming. Have been looking at the Evolution 3 but they only advertise it cutting foam core.
Has to cut Coraplast and gator plus be super accurate trimming prints.
Anything else out there that does the job?
 

Romanf

CGF II, Certified Grumble Framer Level 2
Forum Donor
Joined
May 28, 2021
Posts
383
From
Middle Tennessee Usa
Business
Simply watercolors
The best machine for your purposes is the Keencut Sabre SERIES 2. It can cut foamboard all the way down to tissue paper, and is available in up to 120“ length.

Check it out at Keencut.com

 

Dan Berg

CGF, Certified Grumble Framer
Thread starter
Joined
Feb 15, 2009
Posts
171
From
Mohnton,Pa.
The best machine for your purposes is the Keencut Sabre SERIES 2. It can cut foamboard all the way down to tissue paper, and is available in up to 120“ length.

Check it out at Keencut.com

We don’t use foamboard, only gatorboard. So it has to cut gator with attached prints accurately.
 
Last edited:
Top