geperry
CGF, Certified Grumble Framer
I am cutting lots of moulding made of poplar and am getting fuzzy cuts. Dows anyone have a solution to this annoying problem?
Unfortunately, you are using an out of date browser which is not fully compatible. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
fuzzy moulding cuts
- Thread starter geperry
- Start date
briank
CGF, Certified Grumble Framer
Fuzzy? Are you using a chopper or saw? Sounds like you might have an overly soft batch of wood or your blades might need to be sharpened.
I'm using a framesquare saw and the blades are newly sharpened.
C
Cliff Wilson
Guest
Sorry, but what does "fuzzy" mean?
I get "fuzzy" cuts occasionally, I assume that you have small chipouts along the edge of you moulding after cutting. Ck all alignments, ck blade installed ok, ck all teeth, blade square to table, table sq'd to blade, let blade get to top speed and slow cut down, replace with new blade if all else fails, same problem, get new moulding from reliable source, or get someone to come in with tool and shop experience to critique what you are doing, and offer solutions.