electronic hieght adjustable joiner table

Create a Post
Mark Rogers

Mark Rogers

CGF, Certified Grumble Framer
Joined
Dec 22, 2003
Posts
138
Loc
Dallas, TX
One of our employees that does wood picture frame joining with our automated nailer is much taller than everyone else. We also had issues with keeping our joining support table level with the joiner. Fortunately we were able to design and build a new table that the joiner would sit inside of and would be electronically height and angle adjustable with the use of electric trailer jacks. John no longer has to bend over in order to make sure the fame corner is lined up perfectly on our wood picture frames.
IMG_4442-3.jpg

Cheers,
Mark
http://www.framedestination.com/
 
...or you could have dug a hole in front of it and then just put a board over the hole for the short people!!:thumbsup:

Glad to help!
 
I feel John's pain.

My back is my least favorite body part and bending over for anything is to be sorely (pun intended) avoided.

I have the stand on my VN42 cranked up to the max height that it will go and I have it to the same waist level as John's.

If I were any taller (or the stand any lower), I would have had to do something like that.
 
Create a Post
Back
Top